What does 'Max Power X…X' mean on my Inficon Cygnus 2 and how to resolve it?
The 'Max Power X…X' message on the Inficon Controller appears when the source power reaches the maximum power programmed for an active material. The message disappears when the source power is reduced from the maximum power setting for that active material.
Why does my Inficon Controller show 'Min Power X..X'?
The 'Min Power X..X' message on the Inficon Controller appears during rate control when the source power reaches the programmed minimum power, provided the minimum power is not set to 0.0%. This message will disappear when the source power exceeds the programmed minimum power or when the controller exits rate control.
What does the 'Crystal Switch(ing) X..X' message mean on my Inficon Controller?
The 'Crystal Switch(ing) X..X' message on the Inficon Controller indicates that a multi-crystal sensor is switching to a new crystal position. This message will be replaced with 'Switcher Error' when the sensor switching has reached its next position.
What causes the 'Carousel Open X..X' error on the Inficon Cygnus 2 Controller?
The 'Carousel Open X..X' message on the Inficon Controller indicates that the Crystal12 carousel is not detected as being in place. This message will disappear when the carousel is detected or when the sensor type is set to something other than Crystal12.
What does 'Control Delay X..X' mean on my Inficon Cygnus 2?
The 'Control Delay X..X' message on the Inficon Controller indicates that the delay option is set to Control, and a material has entered the control delay. This message will disappear when the control delay is complete.
General| Technology | Quartz Crystal Microbalance (QCM) |
|---|---|
| Number of Sensors | Up to 6 |
| Power Requirements | 100-240 VAC, 50/60 Hz |
| Communication Interface | Ethernet, RS-232, USB |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Thickness Range | 0.1 Å to 999, 999 Å |
| I/O Interfaces | Ethernet, RS-232, USB |
| Measurement Principle | Quartz Crystal Microbalance |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 70°C |
| Deposition Rate Range | 0.001 to 999.9 Å/s (0.0001 to 99.99 nm/s) |
To Next Page
