3 - 18
Cygnus 2 Operating Manual
3.3.7.3 Comm Page
Datalogging of crystal data is enabled here and RS232 and optional Ethernet
parameters are entered.
Datalog Xtal Info
RS232 / Baud Rate/ Protocol
Ethernet / IP Address/ Net Mask
See section 6.4, COMM Page Parameters, on page 6-3.
3.3.7.4 Message Page
Ten messages of up to 19 characters each can be entered. Display of messages
can be turned on and off using Logic statements.
See section 6.5, MESSAGE Page Set-up, on page 6-5.
3.3.7.5 Date/Time Page
Toggle between date formats and enter the current date and time.
Date Format . . . . . . . . . . . . . . . . . . . Calendar/ Day/ Month/ Year
System Time. . . . . . . . . . . . . . . . . . . See section 6.6, DATE / TIME Set Up, on
page 6-6.
3.3.7.6 Test Page
Allows executing the programmed Material with a dummy rate signal.
Test. . . . . . . . . . . . . . . . . . . . . . . . . . On/Off
Time Compressed . . . . . . . . . . . . . . No/Yes to speed up all times by factor of 10
Advanced Test . . . . . . . . . . . . . . . . . On/Off. Responds to crystal failures in "On"
mode.
See section 6.7, TEST Page Set Up, on page 6-7.
3.3.7.7 Lock Page
Allows setting lock codes to prevent parameter changes or file access.
Program Lock Code/ File Access Code
See section 6.8, LOCK Page Code Set-up, on page 6-8.
3.3.7.8 Audio/Visual Page
Audio Feedback: turns key beep on or off.
LCD Dimmer Time: 0 disables, sets time in minutes for screen to be turned off after
no keys pressed and no Materials are running7.
See section 6.9, AUDIO / VISUAL Page Set Up, on page 6-9.
To Next Page
Loading...
Need help?
General
