Inficon CU1000

6 | Operation CU1000 INFICON
16 / 36 CU1000-operating-instructions-jina54en1-06-(1901)
6.3 Settings and functions
Settings and functions of the control unit are explained in the following. You will find
the settings and functions of the mass spectrometer module LDS3000 you can set
using the control unit in the operating instructions of the mass spectrometer module.
6.3.1 Touch screen settings
The touch screen grays out the parameters if
• the user is not authorized to modify the values,
• the older version of the software run by mass spectrometer module LDS3000 does
not support this parameter.
Scaling of the Q(t)axis
Linear or logarithmic
Lin.
Log.
Control unit Display > Q(t) axis > Linear or logarithmic
Number of decades with logarithmic view
1
2
3
4
Control unit Display > Q(t) axis > Decades
Autoscale
Off (When ”Off”, you can change the appearance by pressing the intersection of the
coordinate axes, then flicking and releasing the desired axis with your finger, or by
pressing and releasing the end of the desired co-ordinate axis)
On
Control unit Display > Q(t) axis > Auto scale
Scaling of the time axis
Scaling of the time axis
15 s
30 s
60 s
120 s
240 s
480 s
960 s
Control unit Display > Time axis > Time axis scale