Inficon CU1000

INFICON Operation CU1000 | 6
CU1000-operating-instructions-jina54en1-06-(1901) 15 / 36
14 - Button "Favorite 1"
You can assign preferred parameters to this button (see Page 19 ). In Fig. 4 the button
"Favorite 1" is assigned the function "ZERO" for example.
15 - Icon for the menu
All functions and parameters of the control unit can be accessed using the "Menu"
key .
A full display of the menu of the menu is included as a file on the USB flash drive
supplied with the LDS3000.
16 - Value axis
Value axis of the leak rate Q(t).
17 - Device of measurement
Device of measurement of the value axis.
6.2 Elements of the error and warning display
Displayed
message
with details
Detailed display
further active
errors or
warnings
(if present)
To the display
further active
errors or
warnings
(if present)
WARNING
Number: 500
Pressure sensor not connected
(Value = 4.23E-2)
Further errors or warnings
To confirm
all messages
Information to
cause or remedy
to the message shown
above
501
502
You will find an overview of possible errors and warnings in the operating instructions
of the LDS3000 (mass spectrometer module), chapter "Warning and error messages".