Inficon CU1000

INFICON Operation CU1000 | 6
CU1000-operating-instructions-jina54en1-06-(1901) 27 / 36
1
Copy the file Flash_LDS3000_MSB_Vxx.xx.xxx.bin into the main directory of a
USB flash drive.
2
Connect the USB flash drive to the USB port on the device.
3
Select: "Functions > Data > Update > MSB".
ð The display shows information on the current and the new software version
as well as on the boot loader.
4
Check the version information.
ð Select the "Start" button to start the update.
ð Do not switch off the device and do not remove the USB flash drive while the
software is being updated! Do not switch off the device and do not remove
the USB flash drive while the software is being updated!
5
Follow the instructions on the touchscreen and wait until the update is complete.
6
If the system displays warning 104 or 106, confirm with "C".
6.3.4.3 Updating the software of the I/O module
The software of the I/O module can be updated from the control unit if the mass
spectrometer module has the software version "MS module 1.02" or higher.
1
Copy the file Flash_LDS3000_IO_Vxx.xx.xxx.bin into the main directory of a
USB flash drive.
2
Connect the USB flash drive to the USB port on the device.
3
Select: "Functions > Data > Update > I/O module"
ð The display shows information on the current and the new software as well as
on the current boot loader.
4
Check the version information.
5
Select the "Start" button to start the update.
ð Do not switch off the device and do not remove the USB flash drive while the
software is being updated!
6
Follow the instructions on the touchscreen and wait until the update is complete.
ð The following tips are shown after selecting the "Start" button on the
touchscreen:
• Connect and switch on the IO1000.
• Activate boot mode (switch DIP S2.3 on and off once).
• When the STATUS LED flashes green, press OK.