Inficon CU1000

INFICON Operation CU1000 | 6
CU1000-operating-instructions-jina54en1-06-(1901) 17 / 36
Display units
Device of pressure
Mbar
Pa
Atm
Torr
Control unit Display > Units (display) > Pressure unit
Measured value
display
Type of graphic display
Diagram
Bar graph
Control unit Display > Measurement view > Measurement view mode
Numeric representation of the measurements
Off
On
Control unit Display > Measurement view > Show value
Display brightness
Display brightness
20 ... 100%
Control unit Display > Brightness > Display brightness
Trigger display on the
touch screen
Selection of the trigger (leak rate threshold) displayed on the touch screen.
1
2
3
4
Control unit Settings > Trigger > Trigger sel.
Assigning favorite
buttons
The favorite buttons offer direct access to individual functions. They can be assigned
with access control "Supervisor" or higher by the user.
Favorite 1: Middle button (see Fig. 4, Page 15).
Favorite 2: Right button
Favorite 3: Button on the bottom right of the main menu.
CAL
ZERO (at AQ instead of ZERO: ZERO
AQ)
Measurement view
Start/Stop
Volume
- - - (= without function)
Check CAL
Flow control
(At AQ additionally: AQ Wizard)