Figure 19 Downloading the project to PSoC
™
HV PA
15. Push the reset switch (SW2) on the CYHVPA-128K-32-001 Evaluation Board and then confirm that the LED
(D7) is blinking.
To debug the project using either IAR I-JET debugger or onboard KitProg3 (CMSIS DAP), select Project>
Download and Debug as shown in Figure 20. For more information on debugging, see the IAR EWARM user
guide.
Getting started with PSoC
™
HV PA family
3 Development environment and tools
Application note 29 002-30264 Rev. *B
2023-04-19
To Next Page
Loading...
