Infineon AN230264 - Connection Diagram with Tools

Table 1 (continued) Board connections
CY8C4147LCE-HV413 (U3) Connection/component
Pin Pin name
16 P0[6] SWDIO for programming
17 P0[5] User push switch / I/O header
18 P0[4] User DIP switch / I/O header
19 P0[3] User LED (green) / I/O header
20 P0[2] User LED (red) / I/O header
21 P0[1] I2C SDA / UART TX / I/O header
22 P0[0] I2C SCL / UART RX / I/O header
23 VCCD Internal digital power (1.8 V): 0.15 μF capacitor
24 VDDD Internal digital power (3.3 V): 0.1 μF, 3.3 μF capacitors
25 VSSD Digital GND
26 VSSL LIN GND
27 NC1 -
28 LIN LIN connector
29 NC2 -
30 VDIAG VBAT voltage sensing with 2.2 kΩ resistor (for diagnostic)
31 VSENSE VBAT voltage sensing with 2.2 kΩ resistor
32 VBAT 12 V power supply input
- EPAD Heat pad (GND)
3.1.2 Connection diagram with tools
PSoC
™
HV PA has an SWD interface to connect with third-party debuggers. The debug pin of SWD is shared with
the GPIO port (P0[6] and P0[7]). For more information, see AN230265 - Hardware design guide for PSoC
™
HV PA
family. Figure 4 and Figure 5 show an example of the basic connection for PSoC
™
HV PA devices. Note that the
external resistors are optional.
1
3
5
7
9
2
4
6
8
10
100nF
GND
GND
VDDD
SWDIO
SWCLK
XRES
SWCLK
SWDIO
XRES
GND
VDDD
4.7k۬
VDDD
4.7k۬
20۬
VDDD
PSoCһх HV PA
Figure 4 Basic connection diagram of MIPI 10-pin connector
Getting started with PSoC
™
HV PA family
3 Development environment and tools
Application note 8 002-30264 Rev. *B
2023-04-19