Infineon AN230264 - Development Environment and Tools; Evaluation Board

3 Development environment and tools
3.1 Evaluation board
The CYHVPA-128K-32-001 Evaluation Board (Figure 2) provides access to all peripherals, resulting in a fully
featured evaluation platform. CYHVPA-128K-32-001 has Arm
®
standard MIPI 10-pin / 20-pin connectors for
the debug interface by third-party interfaces, and Infineon KitProg3 low-level communication interface for
programming and debugging. The evaluation board can be used for the development of soware. For more
information on board details, see the PSoC
™
HV PA Evaluation Board user guide (References).
Pseudo load
(For Wall Adapter)
12V Wall
Adapter
Input
Power
Switch
VBAT
LED &
SW
LIN
Interface
MIPI 10-pin / 20-pin
connector for debug
interface
USB Micro Connector
for KitProg3 program
and UART com port
KitProg3 (PSoC5 LP)
based DUT programming
User SW and LEDs
PSoC™ 4 HV Precision
Analog Device (DUT)
Program
header for
PSoC™ 5LP
I/O Header
for DUT
Reset Switch
Pseudo
Temperature
Sensor
Shunt Resistors
(100 m / 75 m / 50 m / 4.02 Ω)
Battery Input
Connectors
High Current Shunt
Resistor Connectors
(100 μ / 50 μΩ)
Pseudo load
Connectors
(Up to 6 A)
Figure 2 CYHVPA-128K-32-001 Evaluation Board - top view
Figure 3 shows the CYHVPA-128K-32-001 Evaluation Board block diagram.
Getting started with PSoC
™
HV PA family
3 Development environment and tools
Application note 6 002-30264 Rev. *B
2023-04-19