32 33
Factory Reset
Restore factory default
settings
1. Long press the Menu
Button to enter the
main menu.
2. Short press the Up
or Down
Button to
select the factory
reset
menu item.
3. Short press the Menu
Button to open the
factory reset popup
window.
4. The popup has two
options,
and .
Select
to restore
factory settings or
to
cancel.
is selected
by default.
5. Short press the Menu
Button to select
to confirm cancellation and return to the menu; OR
6. Short press the Up
Button to move to and short press the
Menu
Button to confirm the factory reset. The factory settings
will be restored and the FINDERV2 will reboot automatically.
NOTES:
• There is a pause of about 20 seconds before the factory restart
begins. Do not press any buttons during this time.
• A factory reset cannot be undone.
• Restoring factory settings will reformat the internal memory, so
please save any files to alternate media.
• Corrected defective pixels may be cleared and need to be re-
corrected.
• The settings listed below will be reset to the factory defaults:
• Color Palette: White Hot
• Image Brightness: 2
• Image Contrast: 2
• Digital Zoom: ×1
• Ultra-clear mode: O
• Wi-Fi: On
• Video Output: O
• PIP: O
• Digital Compass: O
• Gravity Sensor: O
• Automatic Display-O: O
• Microphone: O
• Units of Measure: Meters
• Calibration Mode: Auto
• Image Hue: W
• Wi-Fi SSID:
FINDER_XXXXX-XXXXXXXX
• Wi-Fi Password: 12345678
A
M
17 : 1 6/2023/10/15
×1.0
M
C W
×1.0
M
17 : 1 6/2023/10/15
Previous Page
Return to the previous
page of the menu
1. Long press the Menu
Button to enter the
main menu.
2. Short press the Up
or Down
Button
to select the previous
page
menu item.
3. Short press the Menu
Button to return to the previous page
main menu.
23. BASIC INSPECTION
It is recommended to carry out a technical inspection before each
use. Please check the following:
• The appearance of the FINDERV2: there should be no cracks in
the body or visible damage.
• The condition of the objective lens and eyepiece: there should
be no cracks, greasy spots, dirt, or other deposits on the lens.
• The rechargeable battery pack should be fully charged.
• The control buttons should be in working order.
24.BASIC MAINTENANCE
Always replace the objective lens cap (1) after use to avoid damaging
or scratching the lens. Never touch the lens directly; oil from your
skin can damage the lens coating and surface.
Basic maintenance should be carried out at least twice a year and
includes the following steps:
• Wipe the surface of the external metal and plastic components
with a clean, dry cotton cloth. Do not use chemical, corrosive,
or abrasive cleaners. Canned air may also be used to clean the
external components.
• Clean the electric contacts and battery slots on the FINDERV2
using a non-greasy organic solvent.
• Check the lens and eyepiece. If necessary, remove any dirt or
sand from the optics; a non-contact cleaning method is preferred.
• Cleaning the exterior of the lens should only be done with the
included microfiber lens cloth or a similar product. Only clean
the lens when it is visibly soiled. Frequent wiping or cleaning can
degrade the anti-reflective lens coating.
A
M
17 : 1 6/2023/10/15
×1.0
M
C W
To Next Page
Loading...
Need help?
General