34 35
25. WARRANTY
At iRayUSA we’re first and foremost hunters and users of our
products and we understand that failure isn’t an option. We also
understand that having to wait extended periods for repair isn’t
something that a customer should have to put up with when
something does go wrong. During your published warranty period,
iRayUSA will repair or replace, at its discretion, any optic that
becomes defective during normal use. Additionally, if we cannot fix
your optic in less than one week, we will oer to replace it with a
replacement product in like or better condition.If you would rather
wait for your specific optic to be repaired, we can handle that too.
We know you’ve never seen this from a thermal manufacturer and
neither have we, and that’s why we started iRayUSA.
Our warranty follows the product and is not tied to the original
owner. The warranty period is tied to the date of sale to the dealer.
This warranty only covers normal use and does not cover cosmetic
damage, normal wear, intentional damage, theft, loss, any act of
God, or a condition caused by use other than intended. Any product
that is modified, opened, or tampered with will void any warranty
coverage. Any serial number damage or alteration on the product will
be considered a modification. Be sure to register your FINDERV2 at
irayusa.com/register.
To return a product for repair:
1. Go to irayusa.com/warranty and click the Request an RMA
button to request an RMA number. Returns will not be accepted
without an RMA.
2. The customer is responsible for shipping the product to
iRayUSA, per the instructions included in the RMA. iRayUSA will
return the product at no cost.
WARRANTY NOTES:
• The one-week timeline starts from the time of receipt of the
product at iRayUSA.
• iRayUSA is not liable for any damages or loss incurred when
shipping to iRayUSA.
• This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state.
Please give us a call at 800-769-7125, visit irayusa.com/warranty, or
email info@irayusa.com with any questions.
26. FCC STATEMENT
FCC ID: 2AYGT-26-00
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by
IRayUSA could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
This device was tested for typical body-supported operations and
use. To comply with RF exposure requirements, a minimum separation
distance of 0.5cm must be maintained between the user’s body and
the handset, including the antenna. Third-party belt-clips, holsters, and
similar accessories used by this device should not contain any metallic
components. Body accessories that do not meet these requirements may
not comply with RF exposure requirements and should be avoided. Use
only the supplied or an approved antenna.
27. GENERAL TROUBLESHOOTING
The troubleshooting table on the next page lists issues that may
occur when operating the FINDERV2. Carry out the recommended
troubleshooting steps in the order shown in the table. Please contact
iRayUSA at 800-769-7125 or irayusa.com/support or an authorized
vendor for assistance before attempting to perform any modifications
or repairs beyond the scope of the troubleshooting procedures in
this manual. Unauthorized repairs or modifications will void your
warranty.
To Next Page
Loading...
Need help?
General