InfiRay Outdoor • Geni Series• Operating Manual www.infirayoutdoor.com
All rights reserved and shall not be copied and distributed in any form without written permission
There is dust or condensate on the interior or
exterior optical surfaces of the lens.
Wipe off the outside optical surfaces with a soft cotton cloth. Let the
riflescope dry by leaving it in a warm environment for 4 hours.
The aiming reticle shifts after firing
rounds.
The riflescope is not mounted securely or the
mount is not fixed on the riflescope.
Check that the riflescope has been securely mounted.
Make sure you are using the same type and caliber of the bullets as
when the riflescope and weapon were initially zeroed.
If your riflescope was zeroed in the summer and using in the winter
(or the other way round), a slight shift of the zero point is possible.
The image of the object being
observed is missing.
Observation through glass.
Remove the glass from the field of vision.
The riflescope will not focus.
Adjust the riflescope according to the Powering On and Image
Setting section.
Check the outer surfaces of the objective lenses and eyepiece and,
where necessary, wipe them from dust, condensation, frost, etc.
In cold weather, you can use special anti-fogging coatings (e.g., the
same as for corrective glasses).
The riflescope can’t connect with
the smartphone and tablet PC.
Too many Wi-Fi signals around the device.
Move the device to an area with no or fewer Wi-Fi signals
Wi-Fi signal is missing or
interrupted
Smartphone or tablet is out of range of a
strong Wi-Fi signal. Or there are obstacles
Replace the device until Wi-Fi signal is stable.
To Next Page
Loading...
