What to do if my InfiRay Thermal cameras riflescope can't connect to my smartphone or tablet?
If your InfiRay Thermal cameras riflescope can't connect to your smartphone or tablet, it could be due to a wrong Wi-Fi password. Ensure you input the correct password. Alternatively, too many Wi-Fi signals around the device may interfere with the connection. Try moving the device to an area with fewer Wi-Fi signals.
How to fix an InfiRay Thermal camera riflescope that won't turn on?
If your InfiRay Thermal camera riflescope won't turn on, the batteries may be completely discharged. Charge the battery to resolve this issue.
Why won't my InfiRay Thermal camera riflescope work with an external power supply?
If your InfiRay Thermal camera riflescope isn't working with an external power supply, the USB cable might be damaged. Try replacing the USB cable. Also, the external power source itself could be discharged, so check the external power source.
How to fix a fuzzy image on InfiRay Thermal cameras?
If the image on your InfiRay Thermal cameras is fuzzy, not clear, or unbalanced, it indicates that calibration is required. Perform image calibration according to the Calibration section of this manual.
What to do if Wi-Fi signal is missing or interrupted on InfiRay Thermal cameras?
If the Wi-Fi signal is missing or interrupted on your InfiRay Thermal cameras, the smartphone or tablet may be out of range of a strong Wi-Fi signal, or there may be obstacles. Replace the device until Wi-Fi signal is stable.
Why does the aiming reticle shift after firing rounds on my InfiRay Thermal cameras riflescope?
If the aiming reticle shifts after firing rounds on your InfiRay Thermal cameras riflescope, it may not be securely mounted, or the mount may not be fixed on the riflescope. Check that the riflescope has been securely mounted. Also, ensure you are using the same type and caliber of bullets as when the riflescope and weapon were initially zeroed. A slight shift is possible if the riflescope was zeroed in summer and is being used in winter, or vice versa.
How to brighten a dark image on InfiRay Thermal cameras?
If the image on your InfiRay Thermal cameras is too dark, the brightness level is likely too low. Adjust the screen brightness.
How do I fix an InfiRay Thermal cameras riflescope that will not focus?
If your InfiRay Thermal cameras riflescope will not focus, adjust the riflescope according to the Powering On and Image Setting section. Check the outer surfaces of the objective lenses and eyepiece and, where necessary, wipe them free of dust, condensation, frost, etc. In cold weather, you can use special anti-fogging coatings.
What causes a clear GUI but a blurry image on InfiRay Thermal cameras?
If the GUI is clear but the image is blurry on your InfiRay Thermal cameras, the lens is not focused. Adjust the image sharpness by rotating the lens adjuster.
How to clean dust or condensate on InfiRay Thermal cameras lens?
To clean dust or condensate on the lens of your InfiRay Thermal cameras, wipe off the outside optical surfaces with a soft cotton cloth. Allow the riflescope to dry by leaving it in a warm environment for 4 hours.
Guidelines for safe operation and temperature limits.
General| Resolution | 384x288 |
|---|---|
| Pixel Size | 12μm |
| NETD | <40 mK |
| Lens | 35 mm |
| Frame Rate | 50 Hz |
| Sensor Type | Uncooled VOx Microbolometer |
| Focus | Manual |
| IP Rating | IP67 |
| Display | OLED, 1024x768 |
| Digital Zoom | 4x |
| Battery Type | Li-ion |
| Spectral Range | 8-14μm |
| Operating Temperature | -20°C to +50°C |
| Weight | 450 g |
To Next Page