InfiRay Geni Series - Trouble Shooting; Fault Diagnosis and Solutions

InfiRay Outdoor • Geni Series• Operating Manual www.infirayoutdoor.com
All rights reserved and shall not be copied and distributed in any form without written permission
the following steps:
➢ Wipe the external surface of metal and plastic parts off dust with a cotton
cloth. Silicone grease may be used for cleaning process.
➢ Clean the electric contacts and battery slots on the riflescope using a
non-greasy organic solvent.
➢ Check the optics of the lens and the eyepiece. If necessary, remove the
dirt and sand from the optics (it is perfect to use a non-contact method).
Cleaning of the exterior of the optics should be done with cleaners
designed especially for this purpose.
25 Trouble Shooting
The table lists all the problems that may occur when operating the riflescope. Carry out the recommended checks and troubleshooting steps in the order shown
in the table. If there are defects that are not listed in the table or it is impossible to repair the defect yourself, return the riflescope for repair service.
Fault
Probable Cause
Solution
Riflescope will not turn on.
Batteries are completely discharged.
Charge the battery.
Riflescope will not work with an
external power supply.
USB cable is damaged.
Replace USB cable.
External power source is discharged.
Check the external power source.
The image is fuzzy, not clear, not
balanced, with strings
Calibration is required.
Perform image calibration according to the Calibration section of
this manual.
The Image is too dark.
Brightness level is too low.
Adjust brightness of screen.
The GUI is clear, but the image is
The lens is not focused.
Adjust the image sharpness by rotating the lens adjuster.