29
Timer
Auto Off Time: aut
omatically turns the projector off after no signals are
detected for a preset number of minutes. If an active signal is received before
the projector powers down, the image will be displayed.
High Altitude Setting
High Altitude Setting: W
e recommend you turn on the High Altitude
Mode when your environment is between 5000' (1500m) and 10,000'
(3000m) above sea level.
Network
Allow you to configure the network settings.
DHCP: Abbr
eviation for Dynamic Host Configuration Protocol. This
protocol automatically assigns IP Address to networked devices.
• When the “DHCP” is set to “On”, it takes some time to obtain IP address
from DHCP server.
• When the "DHCP" is set to "Off", that means user will set IP address by
manually.
IP Address: Numerical address to identify networked computers. This func-
tion can only be used when DHCP is set to Off.
• The IP Address is the number that identifies this projector on the
netw
ork. You cannot have two devices with the same IP Address on the
same network.
• The IP Address “0.0.0.0” is prohibited.
Subnet Mask: A
numeric value to define the number of bits used for a net-
work address of a divided network (or subnet) in an IP Address. This function
can only be used when DHCP is set to Off.
• The Subnet Mask “0.0.0.0” is prohibited.
Default Gateway:
A server (or router) to communicate across networks
(subnets) that are divided by a Subnet Mask. This function can only be used
when DHCP is set to Off.
DNS:
Setup DNS server address when DHCP is disabled.
Mac Address: Abbreviation for Media Access Control Address. Mac
Address is a unique ID number assigned to each network adapter.
Apply:
Save and execute the wired network settings.
Restart Network...: Restar
t network settings.
Status/Service:
Source Info: a read-only display of current source settings.
Projector Info:
a read-only display of current projector settings.
Reset Lamp Hours...:
resets the lamp hours used counter in the Projector
Info menu to zero. Do this only after changing the lamp.
Factory Reset...: r
estores all settings to their factory default settings.
Service Code...: onl
y used by authorized service personnel.
Network Menu
Restart Network...
To Next Page
Loading...
Need help?
General
