33
2
The Tools page allows you to manage the projector, configure the LAN
control settings and remotely access the network operations of this projector.
c
b
a
a. This area is only used with a Crestron Control System. Please contact Creston or
refer to the Crestron user manual for setup information.
b. This area is used for naming the projector, associating it with a particular location,
assigning a responsible party to it, and adjusting network settings.
c. This area is used to set User and Admin passwords. When password protection is
enabled, unauthorized changes to the projector configuration will be avoided.
• To prevent errors, only enter alphanumeric characters on the Tools page.
• After configuring the settings, press the Send button and the data will be
saved in the projector.
• Press exit to go back to the Crestron remote network operation page.
Please pay attention to the input length and character limitations (including character and
punctuation restrictions) listed blow:
• / > < $ % + \ ' " are prohibited.
Category Item Input-Length
Maximum Number of
Characters
Crestron Control
IP Address 15
IP ID 4
Port 5
Projector
Projector Name 22
Location 22
Assigned To 22
Network
Configuration
DHCP (Enabled) (N/A)
IP Address 15
Subnet Mask 15
Default Gateway 15
DNS Server 15
User Password
Enabled (N/A)
New Password 15
Confirm 15
Admin Password
Enabled (N/A)
New Password 15
Confirm 15
To Next Page
Loading...
Need help?
General
