What to do if the Change lamp message appears on my InFocus Projector?
If the 'Change lamp' message appears when you start your InFocus Projector, or if the Lamp light is on, it means the lamp needs to be replaced. Replace the lamp and reset the lamp timer to resolve this issue.
How to fix a blurry image on an InFocus Projector?
If the image from your InFocus Projector is not sharp, try these steps: First, adjust the focus. If that doesn't work, go to the Picture>Advanced menu and adjust the Sharpness setting.
What to do if only the startup screen appears on my InFocus Projector?
If only the start-up screen appears on your InFocus Projector, ensure you have connected an active source. Then, press the Source button on the projector or remote.
Why don’t the projected colors match the source on my InFocus IN82 Projector?
If the projected colors from your InFocus Projector don’t match the source, try the following: Adjust the color, tint, color temperature, brightness, and contrast in the projector's menus. Also, double-check all cable connections to ensure they are secure.
What to do if the image is not square on InFocus IN82?
To correct a non-square image on your InFocus Projector: Adjust the Keystone setting in the Picture menu. If you're using tabletop mode, tilt the projector up or down.
How to center the image on an InFocus Projector screen?
To center the image on the screen with your InFocus Projector: Move the projector, adjust the zoom, and adjust the height until the image is properly centered.
How to troubleshoot no start-up screen on InFocus IN82?
To resolve the issue of no start-up screen on your InFocus Projector: Plug the power cord into the back of the projector, then press the power button on the remote or the projector itself.
Statement of adherence to directives and norms for product safety and performance.
Information on FCC compliance, Canadian standards, and agency approvals.
Details about the projector's features, performance, and technical data.
Instructions for registering the projector online for warranty and updates.
List of accessories and components provided with the projector.
Overview of available video input ports and their quality ranking.
Information on digital video inputs like HDMI and M1-DA/DVI.
Steps to connect power, turn on the projector, and select a source.
Guidance on physically positioning and adjusting the projected image.
Procedures for powering off the projector, including power save and sleep timer features.
Guidance on resolving common setup issues using status indicators and solutions.
Tips for resolving issues with the projector's remote control functionality.
Options to adjust the image's width-to-height ratio for optimal viewing.
Adjusts the clarity of edges in video images for better detail.
Selects color standards for computer and component video inputs.
Configure input source selection, autosource, and SCART RGB.
Adjust projector settings like OSD, rear/ceiling projection, and power modes.
Restores all projector settings to their original factory defaults.
Resets the lamp usage counter after lamp replacement.
Displays projector software, serial number, and lamp status details.
Step-by-step guide for safely removing and installing a new projector lamp.
Codes for programming other remotes to control projector functions.
Technical drawings and measurements for ceiling mount installations.
Settings required for connecting and controlling the projector via RS-232.
Structure and syntax for sending commands to the projector using RS-232.
General| Display Technology | DLP |
|---|---|
| Native Resolution | 1920 x 1080 |
| Zoom Ratio | 1.2x |
| Lamp Life | 3000 hours |
| Inputs | HDMI, Component, S-Video, Composite, VGA |
| Lamp Type | UHP |
| Weight | 12.1 lbs (5.5 kg) |
To Next Page
