31
2 Press the right disk mouse button to display the color selector.
Position the cursor on the desired color, then press the left
mouse button. Press the right button again to close the color
selector.
3 Move the pencil to where you want to start the annotation.
4 Press the left mouse button on the disk mouse. The cursor
changes to an upright pencil.
5 Use the disk mouse to draw your annotation. Press the left
mouse button to finish the annotation.
6 To exit Scribble, press the scribble button. The annotation is
automatically deleted (it cannot be saved).
Standby
When you press standby, the display and audio turn off and the
screen becomes black. After 15 seconds the lamp goes out if you
haven’t pressed any other buttons.
• If you press standby again within 15 seconds, the projector
returns to normal operations immediately.
• If you press standby again after the lamp goes out, there can be
up to a 30-second delay before the lamp turns back on.
Video
When you have more than one source (computer or video) con-
nected to the projector, you select between them by pressing the
button for the source you want.
Press video to display the image from your video player.
Volume
•
To increase the volume, press
• To decrease the volume, press
The volume buttons are auto-repeating; they continue to adjust
the volume as long as you hold them down. Volume adjustments
are saved for each source you have connected.
Downloaded from ProjectorsManual.com Manuals
To Next Page
Loading...
Need help?
General
