InFocus LITESHOW4 - IP and DHCP Settings; Wireless Network Setup

39
IP Setup
You can select
Obtain IP address automatically
or
Use the following IP address
.
IP Address:
The default value is 192.168.100.10.
Subnet Mask:
The default value is 255.255.255.0
Default Gateway:
The default value is 192.168.100.10
DNS Server:
Enter the values for your network
DHCP Server Setup
Enable or disable the DHCP server automatically, or disable it altogether.
Start IP:
The start IP address of DHCP Server.
End IP:
The end IP address of DHCP Server.
Subnet Mask:
Enter the values for your network
Default Gateway:
Enter the values for your network
DNS Server:
Enter the values for your network
Wireless Setup
Wireless LAN:
“Enable” or “Disable” the Wireless LAN.
Embedded AP SSID/Name:
Type the device name.
SSID Broadcast:
SSID string, maximum length is 32 bytes. (No spaces)
Channel:
You can set fixed channel or choose Auto. After powering on the LiteShow, choosing
“Auto” will scan all wireless channels and select one clear channel automatically.
Encryption:
Disable or select a wireless encryption preference (WEP/WPA/WPA2 64-bit or 128-
bit in ASCII or HEX string).
Key:
If Encryption is enabled, a key value must be set based on the selected encryption mode.