13
Adjusting the image
Position the projector to the desired distance from the screen at a 90 degree
angle to the screen. See page 8 for a table listing of screen sizes and
distances.
Remove the projector top cover
a. Slide the tabs on the side toward the
rear of the projector to unlock
the projector top cover.
b. Slide the top toward the front of t
he projector to unhook it from the
projector body.
c. Lift off.
Adjust the zoom or focus.
If the image is square but not centered on the
screen or viewing area, adjust
it by using the lens shift dials. See page 7 for details.
Rotate the elevator feet for granular adjustment of the pr
ojector’s height.
Avoid placing your hands near the hot exhaust vent at the side of the
projector.
Adjust the Contrast or Brightness in the Ba
sic Picture menu. See page 29 for
help with these me
nu adjustments.
horizontal
vertical
zoom
focus
(a)
(b)
(c)
(a)
horizontal
vertical
zoom
focus
Adjust zoom, focus and lens
shift
Adjust height
Release button
Elevator foot
To Next Page
Loading...
Need help?
General
