33
Glow Ring: Controls the brightness level of the glow ring status indicator.
PIN Protect:
The PIN (personal identification number) feature allows you to
password protect your projector. Once you enable the PIN feature, you
must enter the PIN before you can project an image. The default PIN on this
projector is Menu-Up-Down-Select-Source. Use the navigation buttons on the
remote or keypad to enter the correct 5-button press sequence. When all 5
numbers are entered correctly, press the Select button on the remote or key-
pad to select OK. If the message “Wrong PIN” appears, verify the code and
re-enter
it. If you mis-enter a number, you must enter 5 numbers and press
the Select button in order to access the “Wrong PIN” message and re-enter
the code.
To enter the PIN at projector startup:
Power up the projector. The “Enter PIN” dialog box
appears after the
startup screen. Enter the PIN. Use the navigation buttons on the remote or
keypad to enter the correct button press sequence. See the description above
for instructions.
To change the PIN:
Select “Change PIN...” in the Setup menu. Ente
r the existing PIN. Enter the
new PIN. You can navigate between OK and Cancel by pressing the arrow
buttons on the keypad. Select OK or Cancel by pressing the Select button.
Verify the new PIN.
If you lose or forget your custom PIN:
Contact InFocus support at www.infocus.co
m/support.
Serial Port, Baud Rate:
Selects the serial port and baud rate.
Serial Port Echo: Controls wh
ether the serial port echoes characters.
To Next Page
Loading...
Need help?
General
