3
Important Operating Considerati
ons for Safety
• Refer to this guide for proper startup and shutdown procedures.
• Follow all warnings and cautions in this manual and on the projector.
• Place the projector in a horizontal position no greater than 8 degrees off
axis.
• Locate the projector at least 4' (1.2m) away
from any heating or cooling
vents.
• Do not block ventilation openings. Locate the projector in a well-
ventilated area without obstructions to intake or exhaust vents. Do not
place the projector on a tablecloth or other soft covering that may block
the vents.
• Do not place the projector in direct sunlight, humid, greasy or dusty
places or in places where the projector may come into contact with
smoke or steam.
• Do not touch the exhaust vents. This area will become hot while the
projector is being used. Be sure children are kept away from this area.
• Do not look directly into the lens while the projector is being used. Be
especially careful that children do not stare directly into the lens.
• Do not push objects of any kind into this projector through its venting
as object may touch dangerous voltage that could result in a fire or
electrical shock.
• Do not drop the projector.
• Do not spill liquid on the projector. Spilled liquid may damage the
projector.
• Do not place any object on the projector.
• Do not stand or step on the projector.
• Use the power cord provided. Connect
the power cord to a receptacle
with a protective safety (earth) ground terminal. The AC power cord
has a three-pin grounding-type power plug. This plug will only fit a
grounding-type power outlet. This is a safety feature. Do not remove
the grounding pin on the power plug.
• A surge-protected power strip is recomm
ended. Do not overload wall
outlets.
• When disconnecting the power cord, hold the plug, not the cord.
Unplug the projector from the wall outlet, if the projector is unused for
an extended time.
• Wash hands after handling the cables supplied with this product.
• The projector remote control uses batteries. Make sure the batteries’
polarity (+
/-) is aligned correctly. Dispose of used batteries in
accordance with local disposal laws.
• Use an InFocus approved ceiling mount kit for proper fitting,
ventilation and installation. The projector warranty does not cover any
damage caused by use of non-approved ceiling mount kits or by
installing in an improper location.
• When the projector is ceiling mounted, wear protective eyewear to
prevent eye injury before opening lamp door.
• The projector must be installed by a qualified professional in order to
ensure proper operation and reduce the risk of hazards or injury. It is
not recommended you install the projector yourself.
• Refer all service to qualified service personnel. Servicing your own
projector can be dangerous to you and will void the warranty.
• Only use replacement parts specified by InFocus. Unauthorized
substitutions may result in fire, electrical shock, or injury, and may
void the warranty
• Only genuine InFocus lamps are tested for use in this projector. Use of
non InFocus lamps may cause electrical shock and fire, and may void
the projector warranty.
• Hg – Lamp contains mercury. Manage in accordance with local
disposal laws. See www.lamprecycle.org.
• The projector uses a high-pressure mercury glass lamp. The lamp may
fail prematurely, or it may rupture with a popping sound if jolted,
scratched, or handled while hot. The risk of lamp failure or rupture
also increases as the lamp age increases; please replace the lamp when
you see the “Replace Lamp” message.
To Next Page
Loading...
