InFocus X1a User Manual

18
VESA connection
If your video device has a 15-pin VGA output, plug one end of the included
computer cable into the VGA connector on your video source. This connec-
tor may be labeled “To Monitor” on the video source. Plug the computer
cable into the Computer In connector on the projector.
Use the A/V cable’s red and white audio connectors as described on the
previous page (the yellow connectors on the A/V cable are not used).
Component video connection
If your HD video device has component connectors, an optional Compo-
nent to VESA adapter can be used. Plug the component cable into the video
device. Plug the other end of the component cable into the adapter and plug
the adapter Computer in (for VESA) connector. Use the A/V cable’s red
and white audio connectors as described on the previous page (the yellow
connectors on the A/V cable are not used).
Component offers the highest quality video output.
Connect the power cord to the Power connector on the side of the projector
and to your electrical outlet.
NOTE: Always use the power cord that shipped with the projector.
connect computer and
A/V cables
connect via Component to VESA adapter
Component
to VESA
and A/V cables
A/V cables
connect power cable

InFocus X1a Specifications

General

Number of colors	16.78 million colors
Vertical scan range	50 - 85 Hz
Horizontal scan range	31.5 - 80 kHz
Projection technology	DLP
Contrast ratio (typical)	2000:1
Screen size compatibility	2.7' - 21.6' \
Projector native resolution	SVGA (800x600)
Lamp type	SHP
Lamp power	150 W
Light source type	Lamp
Service life of light source	4000 h
I/O ports	VGA 15-pin HDDSUB S-Video 4-pin mini DIN & RCA
Aspect ratio	4:3
Power supply type	100~240V @ 50-60Hz
Dimensions (WxDxH)	249 x 327 x 106 mm
Full HD	Yes
Noise level	37 dB
Certification	UL, c-UL, TUV GS, CE, GOST, C-Tick, NOM, IRAM, FCC B, CISPR22 /EN55022, EN 55024
Power consumption (typical)	200 W
Operating temperature (T-T)	5 - 40 °C

Weight and Dimensions

Weight	3100 g