Thank you for choosing the Element
TM
Auto-coding Blood Glucose Monitoring
System. This booklet has important information you must know about the Element
TM
Auto-coding
Blood Glucose Monitoring System. Please read it carefully.
We understand that self-testing of blood glucose level provides a way to control
your diabetes and may give you peace of mind by testing regularly. As a result
Element
TM
Auto-coding was developed to provide you with a fast and accurate
reading with a convenient and simple process. Our goal at Element
TM
Auto-coding
is to provide the best quality healthcare products coupled with superior customer
service.
Always consult with your healthcare professional before making any changes to
your diabetes management. The Element
TM
Auto-coding Blood Glucose Monitor-
ing System is for in vitro diagnostic use only.
The Element
TM
Auto-coding Blood Glucose Monitoring System is intended for use
outside the body (in vitro diagnostic use only). It should be used only for testing
blood glucose and only with fresh capillary whole blood samples. It should not be
used for the diagnosis of diabetes.
Consult your physician or diabetic healthcare professional about daily manage-
ment of your diabetes and proper use of the glucometer.
Please pay close attention when handling blood. Improper procedures may cause
serious hazards to your health.
The Element
TM
Auto-coding Blood Glucose Monitoring System contains small
parts. Please keep your monitoring system out of reach of children.
Important information
4
www.infopia21.com
Dear Element
TM
Blood Glucose Monitoring System Owner
5
The enzyme glucose oxidase on the blood glucose test strip reads specifically
with the blood glucose. The current generated is converted and displayed as
blood glucose value.
The Element
TM
Auto-coding Blood Glucose Monitoring System is plasma-
calibrated to allow easy comparison of results with laboratory methods.
Blood glucose test meter which is calibrated against a whole blood method may
have different results in comparison to Element
TM
Auto-coding.
The laboratory system used for calibration of the Element
TM
Auto-coding Blood
Glucose Monitoring System is YSI 2300 STAT plus which is equipped with a
glucuse oxidase system.
Note
< Maintaining the Element
TM
Auto-coding blood glucose test meter >
1. Do not assemble or disassemble the blood glucose test meter.
2. It will have to keep in the place where the water does not reach.
3. Avoid getting dirt and moisture.
4. It does not have to keep in storage place of the chemical chemicals or the
place where gas etc occurs.
5. Keep out of direct sunlight.
5
Test Principle
To Next Page
Loading...
