110
8. Restore previous settings using the “Import NVRAM from reserve space“ or
“Restore NVRAM from Files” in the firmware. ID/LUN mapping will be restored.
*The Single controller system’s restore default procedure is complete and for Dual
Controller systems, please continue with the following procedures.
9. Power off the system.
10. Replace Controller A with Controller B (Controller B will be inserted into
Controller A’s slot) While leaving Controller B slot empty with Controller B in slot
A, perform the above steps 1 to 8 to restore Controller B to default settings.
11. Put both Controller A and Controller B into their original positions and power up
the system.
To Next Page
Loading...
