INFOSEC UPS SYSTEM E4 LCD 10K TT - Page 69

INFOSEC UPS SYSTEM – 4 rue de la Rigotière – 44700 Orvault – France – www.infosec-ups.com
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 12 13 AA 59 203 07
68
Note: The following setting code order only appears when the UPS is in Bypass Mode or no-output mode. The setting
code number will change in other modes. For example, when the UPS is in AC mode, the total available setting
becomes 7 only. Then, the “Bypass mode setting” code will become 01, “Battery backup time setting” will become 02,
and soon.
20 programs available list for parameter 1:
Code Description
Bypass /
No Output mode
AC
mode
ECO
mode
CVCF
mode
Battery
mode
Battery
Test
01 Output voltage Y*
02 Output frequency Y
03 Voltage range for bypass Y
04 Frequency range for bypass Y
05 ECO mode enable/disable Y
06 Voltage range for ECO mode Y
07 Frequency range for ECO mode Y
08 Bypass mode setting Y Y
09
Maximum battery discharge time
setting
Y Y Y Y Y Y
10 Reserved Reserved for future options
11 Reserved Reserved for future options
12 Neutral loss detection Y Y Y Y Y Y
13 Battery voltage calibration Y Y Y Y Y Y
14 Charger voltage adjustment Y Y Y Y Y Y
15 Inverter A voltage adjustment Y Y Y
16 Inverter B voltage adjustment Y Y Y
17 Inverter C voltage adjustment Y Y Y
18 Output A voltage calibration Y Y Y
19 Output B voltage calibration Y Y Y
20 Output C voltage calibration Y Y Y
*Y (YES) means that this program can be set in this mode.
** This function allows UPS input phase sequence more flexible. If it is enabled, UPS can adapt several kinds of phase
difference even it works like a single phase UPS. If it is disabled, UPS only can work under standard input phase
sequence among L1, L2, and L3. Please refer to program 17 below for more details about LCD setting.