©2011, Attendance on Demand
®
, Inc. Information in this document is subject to change without notice.
Removes employees from the clock.
Clear all existing application settings (for example, function keys,
employees, transactions, templates and so on) and returns the clock to
original application defaults. This operation does not impact the IP
Configuration that in the Settings, Device, then Device Info menu. When
the clock communicates next time, application settings from the software
are restored to the clock.
Enrolls a proximity badge into the device. If the employee is not assigned
the badge number in the software, this operation results in a mismatched
badge.
Once a badge is enrolled, the badge can be immediately used for punching.
After all badges are registered in the clock, press ESC to exit the menu.
The clock performs synchronization automatically to upload badges to the
system.
Displays the Attendance on Demand database URL.
Displays the MSS2 database URL
Perform full synchronization operation to share employee data, transactions
and settings between the clock and the hosted system.
Select Yes to reload the application.
Select Yes to restart the terminal after exists the menu or the menu times
out. Select No to not restart the terminal. If any clock settings are modified,
select Yes to ensure changes are saved correctly and take effect after the
terminal is restarted. Otherwise, select No.
Displays the clock Flash version.
Displays the clock Application version.
To Next Page
Loading...