©2011, Attendance on Demand
®
, Inc. Information in this document is subject to change without notice.
The Lift Restriction operation allows the supervisor to remove any restriction for
the next badge or template initiated transaction. See Lift Restriction on page 30 for
detailed process.
The Lift Restriction operation allows the supervisor to remove any restriction for
the specified badge or the template associated with the employee badge when the
badge or the finger is used next time. See Lift Badge Restriction on page 31 for
detailed process.
Displays the question “Enable Time Restrictions?”
If there are punch restrictions that prohibit employees from punching at the
clock, press the OK button for Yes.
If there are no punch restrictions, press the MENU button to navigate to No
and press the OK button.
Displays employee names, badge numbers, and the date and time of each
employee’s last punch sorted by employee last name.
Only employees who are punched IN are displayed. Displays employee names,
badge numbers, and the date and time of each employee’s last punch.
Add Punch
The following process describes how to add a punch for an employee. Use the MENU key to navigate
between OK, Cancel and the edit field.
1. Press OK to select the Add Punch operation.
2. In the Badge Number prompt, enter the badge number of the employee to which to add a punch. Press
the synchronization button to erase the number and re-enter it.
3. In the Choose a Date prompt, use the Up and Down arrow to change the employee’s punch day. Press
the synchronization button to reset to the current date.
4. In the Please Enter prompt, enter the employee’s punch time. To correct the time, type numbers to
represent the hours and minutes in order. Press the synchronization button to erase the number and re-
enter it.
Credit Hours
The following process describes how to credit hours for an employee. Use the MENU key to navigate
between OK, Cancel and the edit field.
1. Press the Down arrow to highlight the Credit Hours operation.
2. Press OK to select the Credit Hours operation.
3. In the Badge Number prompt, enter the badge number of the employee to which to credit hours. Press
the synchronization button to erase the number and re-enter it.
To Next Page
Loading...