Ingenico iWL220 - Switching the Paper Roll

19
Switching the paper roll
A special thermal paper roll with a width of 57 mm and a diameter of up to 38 mm is used in the terminal.
When the paper roll is nearing its end, a coloured indicator strip becomes visible indicang that the printer is
about to run out of paper.
If the strip appears, it means that the printer has enough paper for one more receipt.
Aenon!
Poor quality paper can jam the printer and create excessive paper dust. Thermal paper must be stored in a dry
and dark place. Moisture, temperature, fricon, liquids, etc. can aect the characteriscs of the paper. Do not
place a paper roll with wrinkled, wet or damaged paper in the printer.
1
First, open the paper roll cover and li it up
as shown on the illustraon.
2
Remove the empty paper roll from the printer.
3
Slightly unwind the new paper roll and remove the protecve strip
from the edge, if required. Place the new paper roll so that the
paper moves from the boom of the roll towards the front edge.
4
Leave a small amount of paper to extend outside the printer door.
Close the terminal cover by pressing it gently unl it clicks. A small
amount of paper must extend outside the printer. Cut the paper
with the metal strip on the printer.