Ingenico iWL220 - Terminal Security and Care

6
Contactless card transactions
Ingenico iWL220 Payment Terminal
Message on
terminal screen
Acon
Welcome
The terminal is in standby mode. Enter the sum of the terminal transacon in cents
(e. g. if the sum of the transacon is 10.00 EUR, enter 1,000).
Press the green key
aer compleng the entry. Aer entering the sum, one
green light will be on PIN pad.
To correct the sum (one character at a me), press the yellow key
.
To cancel the transacon, press the red key
.
Use the card
Ask the client to place the card on the signal receiver of PIN pad unl a beeping
sound is heard.
Reading the card
Successful
Remove the card
The card has been successfully read if four lights turn on and the device produces a
sound indicang successful reading of the card.
The terminal will connect to the bank.
Transacon is
completed
The terminal will print out the rst receipt.
Take the receipt
and press the key
Tear o the receipt and press the green key
, to print out the second receipt.
To renounce the second receipt, press the red key .
• In the case the transacon exceeds a certain limit for some bank cards , the terminal may require the
signature of the client, and the merchant must verify the signature on the back side of the card. If the
signature is authenc, press the green key on the terminal. If the signature is not authenc, the
goods cannot be sold to the client and the transacon must be cancelled by pressing the red key .
• If the sum of the contactless card transacon exceeds the allowed transacon limit, the PIN pad will
prompt the card to be inserted in the card reader and a chip card transacon will be performed (see “Chip
card transacons”, page 8).
• The rst copy of the receipt remains with the merchant, the second one is handed to the buyer.
•