8
5. Verify the ECR URL is correct. If not, enter the IP address of the register for
which the Ingenico payment device should be paired.
6. Tap the Save button on the screen OR press the green button to confirm.
7. The device will exit to the Config screen.
8. Tap ECR IP on the screen AND press the green button to confirm.
9. Verify the ECR IP is correct. If not, enter IP address of the register to which the
Ingenico payment device should be paired.
10. Tap the save button on the screen or press the green button to confirm
11. Exit the AurusPulse Menu by pressing the red cancel button. The device
may reboot or exit to the Welcome (PAR Pay) screen.
If you run into any issues or have questions, please contact our support team for
assistance.
To Previous Page
Loading...
