Inhep Digital Security IDS 404 - LOCATIONS 84-99 Secondary Telephone Number; Communicator Reporting Codes (Locations 100-153)

IDS404 INSTALLER MANUAL NO. 700-277-02A ISSUED SEPT 2004 VER 1.02 39
IDS404 INSTALLER MANUAL
99-48SNOITACOLrebmuNenohpeleTyradnoceS
.oN.coL48586878889809192939495969798999
These locations contain the secondary telephone number that may be
up to sixteen digits long. The same procedures apply as for the
Primary Telephone Number.
Communicator Reporting Codes (Locations 100-153)
With the exception of Contact ID, all other communications formats
are 4 x 2 reporting formats i.e. a 4 digit account code will be reported
with a 2 digit reporting code. It will be noted that some reporting
functions require that both digits of the reporting code be programmed
while others only require a single digit to be programmed. Reporting
codes with only one digit will have the second digit added
automatically by the panel. An explanation is provided under each
reporting code. It is however important to note that wherever space is
provided for the programming of 2 reporting digits i.e. Locations 106
and 107 for zone 1 reporting code BOTH DIGITS MUST BE
PROGRAMMED
.
NOTE:
! To disable any of the reporting codes program a [0] into the
locations for both digit 1 and digit 2.
! All reporting codes that require a “0” to be reported must be
programmed as a [10] i.e. An “A” will be reported in the place of
the “0” as per the hexadecimal values below.
eulaVlaciremuN
123456789 011121314151
eulaVlamicedaxeH
123456789ABCDEF
101-001SNOITACOLedocgnitropersseruD
This code will be reported if the panel is disarmed using the duress
code (User Code 15 is the duress code - see the User Manual).
301-201SNOITACOLedocgnitropercinaPdapyeK
This code will be reported if the panic button [P] on the keypad is
pressed.