4 0 IDS404 INSTALLER MANUAL NO. 700-277-02A ISSUED SEPT 2004 VER 1.02
IDS404 INSTALLER MANUAL
501-401SNOITACOLedocgnitroperrepmaTdapyeK
The keypad tamper code will be reported if multiple attempts are made
to disarm the panel using the wrong user code. The code will be
reported after 16 incorrect keystrokes i.e. four incorrect user codes.
121-601SNOITACOLsedocgnitroperenoZ
snoitacoL edoCgnitropeR
701-6011enoZ
901-8012enoZ
111-0113enoZ
311-2114enoZ
511-411a1enoZ
711-611a2enoZ
911-811a3enoZ
121-021a4enoZ
Zone reporting codes will be reported if a violation of a zone causes an
alarm condition. Various conditions will apply as to when an alarm
condition will be registered. These conditions are determined by the
zone characteristics as programmed into locations 1 to 8.
NOTE: When Contact ID is used, the appropriate Contact ID code
must be reported depending on the value programmed into location 11.
321-221SNOITACOLedocgnitroperliaFCA
The AC fail will only be reported if the AC power is lost for a period
longer than the delay programmed into location 19.
521-421SNOITACOLedocgnitroperlarotseRCA
The AC restoral code will be reported if the AC power was lost for a
period longer than the delay programmed into location 19 and only
after the AC power has been restored for the same period of time.
To Next Page
Loading...