inVoca User Guide - Page 11
To train your first command (Teach inVoca to turn on the TV) follow
these steps:
Train inVoca to Turn on the TV
You Do This inVoca Response
Press the [Train] button inVoca will say, "Say a word."
When the inVoca is ready to listen,
the LED will light green.
Say a one or two-word voice
command. For example,
"TV Power."
inVoca will ask you to repeat the
command.
Say the same word again If the two words match, inVoca
will say "Press a button."
Press the first button that
you wish to associate with
the voice command ([TV] in
this example) within 15
seconds.
inVoca will respond with, "Button
accepted. Press another button."
Press the next button in the
sequence (in this example,
[Power]) within 15 seconds.
inVoca will say, "Button accepted.
Press another button."
Since you have now
completed the sequence,
press the [Train] button.
Since you have created a sequence
of more than one button, inVoca
will say, "macro assigned."
The voice-command TV Power is now assigned to the macro sequence
[TV] ÿ [Power], and is equivalent to pressing the [TV] button, then
the [Power] button.
If you wish to test the command that you have trained now, you will
need to first "wake up" inVoca by pressing the [Wake_up] button.
(See Using Voice Commands, page 16.) To program inVoca to turn
your cable box on and off, follow the above procedure, but use the
[CBL/SAT] button instead of the [TV] button, and use the command
"Cable Power."
inVoca User Guide - Page 12
Now, using the same procedure, let's set up the most common
commands.
Train inVoca To Go Up To The Next Channel
You Do This inVoca Response
Press [Train] inVoca will say, "Say a word." The
LED will light green.
Say the command "Next
Channel."
inVoca will say "Repeat."
Say "Next Channel"again. If the two commands match, inVoca
will say "Press a button."
Press [C+] inVoca will respond with, "Button
accepted. Press another button."
Press [Train] inVoca will say, "Button assigned."
Train inVoca To Go Down A Channel
You Do This inVoca Response
Press [Train] inVoca will say, "Say a word." The
LED will light green.
Say the command
"Previous."
inVoca will say "Repeat."
Say "Previous" again. If the two commands match, inVoca
will say "Press a button."
Press [C-] inVoca will respond with, "Button
accepted. Press another button."
Press [Train] inVoca will say, "Button assigned."
(As with any universal remote control, you will need to let inVoca
know what device it is to control. For example, if you use a cable or
DSS box to change channels, remember to train the [CBL/SAT] button
as above, and select "Cable" or "DSS" prior to changing channels.)
To Next Page
Loading...
