© MASS ELECTRONICS Pty Ltd 2008
Page 6
DS 9.05 - M2K05 - Micro2000 Controller
August 2013
1. Never touch the I/O terminals while power is being supplied.
2. Never attempt to disassemble the unit while power is being supplied.
3. Emergency stop circuits, limit circuits, interlock circuits and similar safety measures must be provided.
4. The Micro2000 outputs may remain On or O due to burning or deposition of the output relays. External
safety measures must be provided for such problems to ensure safety in the system.
5. Follow Innotech wiring diagrams and the installation / wiring instructions contained in this Datasheet.
The following describes potentially hazardous situations which, if not avoided,
could result in death, serious or minor injury, or property damage.
CAUTION
YOUR DISTRIBUTOR
Australian Owned, Designed & Manufactured
by Mass Electronics Brisbane
Phone: +61 7 3421 9100 Fax: +61 7 3421 9101
Email:
sales@innotech.com.au
www.innotech.com.au
The INNOTECH device and the word INNOTECH are registered or unregistered trademarks of Mass Electronics Pty Ltd in Australia, USA and other countries
To Previous Page
Loading...
Need help?
General
