Inogen TAV - Basic Device Operation

10
Basic Device Operation
1. Turn the device ON:
Press and hold the power button for 1
full second until the lights turn on and
the device beeps.
2. Select the breathing mode:
Press the top mode button to select the
desired mode. The light for the selected
mode will blink.
º Pulse (pulsed-dose)
º Tidal Assist
º Constant (continuous ow)
3. Select the ow rate:
Use the -/+ buttons to select the
prescribed ow setting (1-5). The green
light for the selected ow rate will blink.
Each press on the -/+ buttons decreases
or increases the ow setting by 1 unit.
4. Turn the device OFF*:
Press and hold the power button for 3
full seconds until the lights turn o and
the device beeps twice.
The TAV® system provides 3 modes of
operation and 5 ow settings for each mode.
The mode and ow settings can be changed
based on your prescribed level of therapy.
Before turning on the device, make sure that
the supply tubing and the nasal pillow
interface are connected. Also make sure
that the gas supply is turned on.