Inogen TAV - Cleaning and Maintenance

16
Cleaning and Maintenance
Device Cleaning and Maintenance:
Weekly and as needed:
• Wipe the external surfaces of the device with a slightly damp
cloth or 70% isopropyl alcohol.
DO NOT ALLOW YOUR DEVICE TO GET OVERLY WET
Doing so may cause the TAV® device to malfunction
Before Each Use:
• Inspect your nasal pillow interface and
make sure it is clean and free of any
debris or build-up. If needed, use the
periodic cleaning method (below) to
clean the nasal pillow interface.
• Inspect your nasal pillow interface for
any damage (e.g., tears, loose parts,
etc.). Replace the nasal pillow interface
with a new one if you see any damage.
Periodically (or as needed):
• Clean your nasal pillow interface using
warm water and liquid dish soap:
º Submerge the nasal pillow
interface in a pan of lukewarm,
clean drinking water with a
small amount of liquid dish soap
(e.g., Dawn®). Agitate and wipe
gently to remove any debris.
º Rinse the pillows thoroughly
using warm, clean drinking
water.
º To dry, hold the nasal pillow
interface with the pillows-end
facing down. Shake the nasal
pillow interface gently to
remove any excess water from
the pillows or tubing.
º To remove any water remaining
inside the pillows or tubing:
Nasal Pillow Interface Cleaning and Maintenance