Inogen TAV - Using Tidal Assist Mode

12
Using Tidal Assist Mode
Tidal Assist Mode provides a larger pulse of
supply gas at the start of each breath than
the Pulse Mode with additional volume assist
with room air. The amount of volume assist
and delivered source gas depend upon the
selected ow setting.
Before turning on the device, make sure that
the supply tubing and nasal pillow interface
are connected. Also make sure that the gas
supply is turned on.
1. Turn the device ON (if o):
Press and hold the power button for 1
full second until the lights turn on and
the device beeps.
2. Select the breathing mode:
Press the top mode button to select the
Tidal Assist mode. The Tidal Assist mode
light will blink.
3. Select the ow setting:
Use the -/+ buttons to select the
prescribed ow rate (1-5). The green
light for the selected ow rate will blink.
Each press on the -/+ buttons decreases
or increases the ow rate setting by 1
unit.