6
To insert a battery:
1. Place both thumbs on the battery cover
door. Slide the battery cover forward.
2. Gently swing the cover back.
3. Insert a fresh AA battery with the
negative (at) end placed against the
spring. If replacing a battery, remove
the used battery rst. Ensure unit is o
before replacing a used battery.
4. Swing the cover to the forward position.
5. Place both thumbs on the battery cover
door. Slide the battery door back until a
slight click is felt.
Device Connections
When looking at the front of the device, the
small connector on the bottom left side (A) is
for connecting your nasal pillow interface.
The large connector on the bottom right side
(B) is for connecting the supply tubing from
the gas source (see page 8).
Connecting the Nasal Pillow
Interface
Attach the nasal pillow interface tubing to the
small connector on the bottom left side of the
device. Make sure that the tubing is pressed
rmly onto the connector.
A B
To Next Page
Loading...
