Inogen TAV - Using Pulse Mode

11
Using Pulse Mode
1. Turn the device ON (if o):
Press and hold the power button for
1-second until the lights turn on and the
device will beep.
2. Select the breathing mode:
Press the top mode button to select the
Pulse mode. The light for pulse mode
will blink.
3. Select the ow rate:
Use the -/+ buttons to select the
prescribed oxygen ow setting (1-5).
The green light for the selected ow rate
will blink. Each press on the -/+ buttons
decreases or increases the ow rate
setting by 1 unit.
Pulse Mode provides oxygen therapy similar
to “pulse-dose” or “conserver” type oxygen
devices. In Pulse Mode, the TAV® device
provides a measured dose of oxygen at the
start of each breath. The amount of oxygen
depends on the selected ow setting.
Before turning on the device, make sure that
the supply tubing and nasal pillow interface
are connected. Also make sure that the gas
supply is turned on.