Inovance GR10-EC-6SW - Wiring Guidelines; Wiring Cautions; Operation and Maintenance Guidelines; Operation & Maintenance Warnings

4
CAUTION
◆ Prevent dropping metal 󶍾lings and wire ends drop into ventilation holes of the PLC at wiring.
Failure to comply may result in 󶍾re, fault and malfunction.
◆ The external wiring speci󶍾cation and installation method must comply with local regulations.
For details, see the wiring section in this guide.
◆ To ensure safety of equipment and operator, use cables with su󶎀cient diameter and connect
the cables to ground reliably.
◆ Ensure that all cables are connected to the correct interface. Failure to comply may result in
module and external equipment fault.
◆ Tighten bolts on the terminal block in the speci󶍾ed torque range. If the terminal is not tight,
short-circuit, 󶍾re or malfunction may be caused. If the terminal is too tight, fall-o󶍽, short-circuit,
󶍾re or malfunction may be caused.
◆ If the connector is used to connect with external equipment, perform correct crimping or
welding with the tool speci󶍾ed by manufacturer. If connection is in poor contact, short-circuit,
󶍾re or malfunction may be caused.
◆ A label on the top of the module is to prevent foreign matters entering the module. Do not
remove the label during wiring. Remove it before operation for ventilation.
◆ Do not bundle control wires, communication wires and power cables together. They must be
run with distance of more than 100 mm. Otherwise, noise may result in malfunction.
◆ Select shielded cable for high-frequency signal input/output in applications with serious
interference so as to enhance system anti-interference ability.
Operation and Maintenance
WARNING
◆ Maintenance & inspection must be carried out by quali󶍾ed personnel.
◆ Do not touch the terminals while the power is on. Failure to comply may result in electric shock or malfunction.
◆ Disconnect all external power supplies of the system before cleaning the module or re-
tightening screws on the terminal block or screws of the connector. Failure to comply may
result in electric shock.
◆ Disconnect all external power supplies of the system before removing the module or connecting/
removing communication wirings. Failure to comply may result in electric shock or malfunction.
CAUTION
◆ Get with the guide and ensure safety before online modi󶍾cation, forcible output, and RUN/
STOP operation.
◆ Disconnect the power supply before installing/removing the extension card.
Disposal
CAUTION
◆ Dispose of the product as industrial waste.