Inovance H5U Series - Input Specifications

8
Item Speci󶍾cations
IP rating IP20
Net Weight 0.46kg
Altitude 2000m
Pollution degree 2
Overvoltage II
1.4 Input Speci󶍾cations
Input signals can be bipolar voltages. The signal status is OFF when the absolute
voltage value is less than 5.0 V; ON when the absolute voltage value is more than
15.0 V; and unde󶍾ned when the absolute voltage value is in the range from 5.0 V
to 15.0 V.
Item
High-speed
Input (X0–X3)
Medium-speed
Input (X4–X7)
General
Input (X10–X17)
Signal Input Mode
Sink input when the SS0/SS1 terminal is short-circuited to 24
V; Source input when the SS0/SS1 terminal is short-circuited
to 0 V
Electrical
proper-
ties
Input DC 24V 1.5A
Input
impedance
2 kΩ 3.3 kΩ 4.3 kΩ
Input ON
Input current
> 7.5 mA
Input current
> 4.5 mA
Input current
> 3.5 mA
Input OFF
Input current
< 2.5 mA
Input current
< 1.5 mA
Input current
< 1.5 mA
Filter
Digital 󶍾lter
Digital 󶍾lter setting supported for high-speed inputs (X0–X3)
and medium-speed inputs (X4–X7)
Hardware 󶍾lter Hardware RC 󶍾lter for general inputs (X10–X17), about 15 ms
High-speed function
High-speed counting and interrupt at X0–X3, with the
frequency 200 kHz
Common terminal
2 common terminals: SS0 for X0–X3 (high-speed inputs) and
SS1 for X4–X17 (medium-speed inputs and general inputs)
NOTE
◆
The supply voltage must not exceed 26.4 V when all inputs are ON.
◆
The low-speed input 󶍾lter time is conceptualized as the RC time.
◆
The response time is about 4 μs when medium-speed inputs are
ON and about 35 μs when medium-speed inputs are OFF.