Inovance IMC30-6G Series - Page 16

- 15 -
3 Hardware Connection
The wiring is as follows:
7$$ 7
 %(/%
 %*3
 %*3
%(/%
%*3
%*3
*.$(
$.1
5XJTUFEQBJSTIJFMEFE
1PTJUJPODPNQBSJTPO
PVUQVUEFWJDF
34MFWFM
Figure 3-1 Wiring of position comparison output (RS422 level)
7$$ 7
 %(/%
 $.1@
 $.1@
%(/%
$.1 
$.1 
*.$(
$.1
5XJTUFEQBJSTIJFMEFE
1PTJUJPODPNQBSJTPO
PVUQVUEFWJDF
PQUPDPVQMFS
Figure 3-2 Wiring of position comparison output (optocoupler)
If there is no device for receiving RS422 level in the position comparison input circuit,
a level conversion module needs to be added. The wiring of this module is shown in
the following 󶍾gure:
7$$7
 %(/%
 $.1@
 $.1@
%(/%
$.1
$.1
*.$(
$.1
%J珜FSFOUJBMUPTJOHMFFOEFENPEVMF
DMPTFUP7TJOHMFFOEFE
USJHHFSJOHEFWJDF
0QUPDPVQMFS
$0.
7TJOHMFFOEFE
USJHHFSJOHEFWJDF
7
0(/%
5XJTUFEQBJSTIJFMEFE