Inovance IMC30-6G Series - Wiring of Stepper Control Modes

- 33 -
3 Hardware Connection
3.9.2 Wiring of Stepper Control Modes
Open-loop control on the stepper motor does not require external feedback, and the
wiring is shown in the following 󶍾gure.
NOTE
◆ Determine whether to connect an external resistor R based on the
descriptions of the stepper drive, and choose a proper resistance
based on the data from the drive. This resistor is not required for
LEADSHINE DM series stepper drive.
 "-.
 (/%
 07$$
 7$$ 7
 %(/%
 %*3 
 %*3
 1-64& 
 1-64& 
 /$
7
(/%
7
"-.
%(/%
%*3
%*3
1-64& 
1-64& 
 40/ &/"
&/"
&/"
5XJTUFEQBJSTIJFMEFE
4UFQQFSESJWF
*.$(
"9*4 "9*4 
"-.
3