Inovance MD200 - Page 41

5 Parameter Table
- 40 -
Para. No. Para. Name Setting Range Default Comms. Address
F8-54
Output power correction
coefcient
0.0% to 200.0% 100.0% 0xF836/0x0836
F8-55 Emergency deceleration time 0.0 to 6500.0 s 10.0s 0xF837/0x0837
F8-57
Speed synchronous control
selection
0: Disabled
1: Enabled
0 0xF839/0x0839
It selects whether to enable the speed synchronous control function.
This function means direction data communication between two or more AC drives via CANlink, implementing target frequency of one
or more slaves to be synchronized to that of the master.
When this function is enabled, CANlink communication addresses of the master and slaves are matched automatically. The baud rate
in speed synchronous control is set in Fd-00.
F8-58
Master and slave selection in
synchronous control
0: Master
1: Slave
0 0xF83A/0x083A
It is used to select whether the AC drive is master or slave. When the AC drive is slave, set F0-03 = 9 to set frequency reference via
communication.
Group F9: Fault and Protection
F9-00 Motor overload protection
0: Disabled
1: Enabled
1 0xF900/0x0900
F9-01 Motor overload protection gain 0.20 to 10.00 1.0 0xF901/0x0901
F9-02
Motor overload pre-warning
coefcient
50% to 100% 80% 0xF902/0x0902
F9-07
Detection of short-circuit to
ground upon power-on
0: Disabled
1: Enabled
1 0xF907/0x0907
F9-08 Braking unit applied voltage 310.0 V to 800.0 V
Single phase:
378.0 V
Three phase:
700.0 V
0xF908/0x0908
F9-09 Auto reset times 0 to 20 0 0xF909/0x0909
F9-10
Selection of DO action during
auto reset
0: Not act
1: Act
0 0xF90A/0x090A
F9-11 Delay of auto reset 0.1 s to 100.0 s 1.0s 0xF90B/0x090B
F9-13 Output phase loss protection
0: Disabled
1: Enabled
1 0xF90D/0x090D