45
When the inverter starts running from the starting frequency, if the reference frequency is lower than
the frequency lower limit during the running process, then the inverter will always be running with
frequency lower limit till it stops or the reference frequency is higher than the frequency lower limit.
Of which, maximum output frequency frequency upper limit frequency lower limit
F6-03 Carrier frequency
Default Depending on the inverter
model
Setting range 0.5kHz ~ 16.0kHz
Adjusting the carrier frequency may have influences on the following performances:
Carrier frequency Low High
Motor noise High Low
Output current wave performance Poor Good
Motor temperature rise High Low
Inverter temperature rise Low High
Inverter load capacity Large Small
Leakage current Small Large
Radiation interference Small Large
The inverter derates the load capacity by 5% for every 1kHz above the default carrier wave
frequency.
F6-04 Jog frequency
Default 2.0Hz
Setting range 0.0 Hz ~ maximum frequency
It is used to define the reference frequency and acceleration time of the inverter when jogging.
Follow the start mode 0(F0-15, direct start) and the stop mode 0 (F0-16, deceleration stop) to start
and stop the jogging process.
F6-05 Jog acceleration time (acceleration time 2)
Default 20.00s
Setting range 0.00s ~ 3000.0s
F6-06 Jog deceleration time (deceleration time 2)
Default 20.00s
Setting range 0.00s ~ 3000.0s
The jog acceleration time refers to the time required for the inverter to accelerate from 0Hz to the
maximum output frequency (F6-00).
The jog deceleration time refers to the time required for the inverter to decelerate from the maximum
frequency (F6-00) to 0Hz. The jog acceleration/deceleration time is also used as the
acceleration/deceleration time 2 and the deceleration time of Low voltage compensation.
To Next Page
Loading...
