Inovance MD800 Series - Page 76

Commissioning and Trial Run
‑75‑
Parameter
No.
Communication
Address
Parameter Name Setting Range Default Unit Property
F2‑22 61974 Output voltage filter
time
0.000s to 0.010s 0.000 s Modifiable
in any states
F2‑23 61975 Zero speed lock 0: Disabled
1: Enabled
0 ‑ Modifiable
only at stop
F2‑24 61976 SVC/PMVVC
overvoltage
suppression
coefficient KP
0–1000 40 ‑ Modifiable
in any states
F2‑25 61977 Acceleration
compensation gain
0–200 0 ‑ Modifiable
in any states
F2‑26 61978 Acceleration rate
compensation filter
time
0–500 10 ‑ Modifiable
in any states
F2‑27 61979 SVC/PMVVC
overvoltage
suppression
0: Disabled
1: Enabled
1 ‑ Modifiable
in any states
F2‑28 61980 Cut‑off frequency of
torque filter
50–1000 Hz 500 Hz Modifiable
in any states
F2‑29 61981 Synchronous motor
initial position angle
detection current
50–180 80 ‑ Modifiable
in any states
F2‑30 61982 Speed loop parameter
auto‑calculation
0: Disabled
1: Enabled
0 ‑ Modifiable
only at stop
F2‑31 61983 Expected speed loop
bandwidth at high
speed
1.0–200.0 Hz 10.0 Hz Modifiable
in any states
F2‑32 61984 Expected speed loop
bandwidth at low
speed
1.0–200.0 Hz 10.0 Hz Modifiable
in any states
F2‑33 61985 Expected speed loop
bandwidth at zero
speed
1.0–200.0 Hz 10.0 Hz Modifiable
in any states
F2‑34 61986 Expected speed loop
damping ratio
(unchanged generally)
0.100–65.000 1.000 ‑ Modifiable
in any states
F2‑52 62004 Decoupling control 0: Disabled
1: Enabled
0 ‑ Modifiable
only at stop
F2‑53 62005 Generating power
limit function
0: Disabled
1: Enabled
0 ‑ Modifiable
only at stop
F2‑54 62006 Generating power
limit value
0.0% to 200.0% 0.0 % Modifiable
only at stop
F2‑55 62007 Magnetic flux closed
loop mode selection
0–1111 10 ‑ Modifiable
only at stop
F2‑56 62008 AC drive output
current upper limit
0.0% to 170.0% 150.0 % Modifiable
only at stop