Inovance MD800 Series - Page 80

Commissioning and Trial Run
‑79‑
Parameter
No.
Communication
Address
Parameter Name Setting Range Default Unit Property
F4‑01 62465 DI1 function selection 0: No function
1: Forward RUN (FWD) or
running command
2: Reverse RUN (REV) or
running direction
3: Three‑wire control
4: Forward jog (FJOG)
5: Reverse jog (RJOG)
6: Terminal UP
7: Terminal DOWN
8: UP and DOWN setting
clear (terminal, operating
panel)
9: Fault reset (RESET)
10: External fault NO input
11: External fault NC input
12: User‑defined fault 1
13: User‑defined fault 2
14: Multi‑reference
terminal 1
15: Multi‑reference
terminal 2
16: Multi‑reference
terminal 3
17: Multi‑reference
terminal 4
18: Acceleration/
deceleration selection
terminal 1
19: Acceleration/
deceleration selection
terminal 2
20: Acceleration/
Deceleration prohibition
21: Command source
switchover terminal 1
22: Command source
switchover terminal 2
23: Frequency reference
switchover
1 ‑ Modifiable
only at stop