Commissioning and Trial Run
‑87‑
Parameter
No.
Communication
Address
Parameter Name Setting Range Default Unit Property
(continued) 62721 DO1/RO1 function
selection
25: Zero current state
26: Current 1 reached
output
27: Current 2 reached
output
28: IGBT temperature
reached
29: Set count value
reached
30: Designated count value
reached
31: Length reached
32: Frequency being
limited
33: Torque being limited
34: AI1 input limit
exceeded
35: AI1 > AI2
36: PLC cycle completed
37: Communication setting
38: STO‑EDM
39: Reserved
40: Zero‑speed running (no
output at stop)
41: Zero‑speed running 2
(valid at stop)
42: Reserved
43: Reverse running
44–50: Reserved
3 ‑ Modifiable
in any states
F5‑02 62722 DO2/RO2 hardware
source
Same as F5‑00 0 ‑ Modifiable
in any states
F5‑03 62723 DO2/RO2 function
selection
Same as F5‑01 15 ‑ Modifiable
in any states
F5‑04 62724 DO3/RO3 hardware
source
Same as F5‑00 0 ‑ Modifiable
in any states
F5‑05 62725 DO3/RO3 function
selection
Same as F5‑01 0 ‑ Modifiable
in any states
F5‑06 62726 DO4/RO4 hardware
source
Same as F5‑00 0 ‑ Modifiable
in any states
F5‑07 62727 DO4/RO4 function
selection
Same as F5‑01 0 ‑ Modifiable
in any states
F5‑08 62728 DO5/RO5 hardware
source
Same as F5‑00 0 ‑ Modifiable
in any states
F5‑09 62729 DO5/RO5 function
selection
Same as F5‑01 0 ‑ Modifiable
in any states
F5‑10 62730 DO1/RO1 output delay 0.0s to 3600.0s 0.0 s Modifiable
in any states
To Next Page
Loading...
