Inovance MD800 Series - Page 94

Commissioning and Trial Run
‑93‑
Parameter
No.
Communication
Address
Parameter Name Setting Range Default Unit Property
F8‑04 63492 Deceleration time 2 0.0s to 6500.0s Model
dependent
s Modifiable
in any states
F8‑05 63493 Acceleration time 3 0.0s to 6500.0s Model
dependent
s Modifiable
in any states
F8‑06 63494 Deceleration time 3 0.0s to 6500.0s Model
dependent
s Modifiable
in any states
F8‑07 63495 Acceleration time 4 0.0s to 6500.0s Model
dependent
s Modifiable
in any states
F8‑08 63496 Deceleration time 4 0.0s to 6500.0s Model
dependent
s Modifiable
in any states
F8‑09 63497 Jump frequency 1 0.00–655.35 Hz 0.00 Hz Modifiable
in any states
F8‑10 63498 Jump frequency 2 0.00–655.35 Hz 0.00 Hz Modifiable
in any states
F8‑11 63499 Jump frequency band 0.00–5.00 Hz 0.00 Hz Modifiable
in any states
F8‑12 63500 Jump frequency
during acceleration/
deceleration
0: Disabled
1: Enabled
0 ‑ Modifiable
in any states
F8‑13 63501 Forward/Reverse run
switchover dead‑zone
time
0.0s to 3000.0s 0.0 s Modifiable
in any states
F8‑14 63502 Reverse run 0: Allowed
1: Prohibited
0 ‑ Modifiable
in any states
F8‑15 63503 Running mode when
frequency reference
lower than frequency
lower limit
0: Run at frequency lower
limit
1: Stop
2: Run at zero speed
0 ‑ Modifiable
in any states
F8‑17 63505 External fault NO
input mode
0: Valid at any time
1: Valid only during
running
0 ‑ Modifiable
only at stop
F8‑18 63506 External fault NC
input mode
0: Valid at any time
1: Valid only during
running
0 ‑ Modifiable
only at stop
F8‑19 63507 Accumulative power‑
on time threshold
0–65000 h 0 h Modifiable
in any states
F8‑20 63508 Accumulative running
time threshold
0–65000 h 0 h Modifiable
in any states
F8‑21 63509 Startup protection 0: Disabled
1: Enabled
0 ‑ Modifiable
in any states
F8‑22 63510 Frequency detection
value 1 (FDT1)
0.00–655.35 Hz 50.00 Hz Modifiable
in any states
F8‑23 63511 Frequency detection
hysteresis 1 (FDT1)
0.00 to F8‑22 2.50 Hz Modifiable
in any states